View Full Version : ZR4 on Ninja 650r
roninmd
10-22-2010, 12:57 AM
Just tested these using a tv remote. The front heads work great but the rear head doesn't respond. If there was something wrong with the rear connection, the display would indicate a rear connection error. So, I don't think it's the line. Anyone have any ideas? Could it be a bad photodiode? or is the rear license light interfering with IR sensitivity? I'm also using a Bel vector 995 as the zr4 display. Your guess is as good as mine.
http://www.youtube.com/watch?v=_oMig9E-pcA
AirMoore
10-22-2010, 09:07 AM
Sometimes remotes are not a reliable way of setting off jammers... just sayin'.
GreenRadar
10-22-2010, 02:32 PM
try one of these, it'll be more effective of testing, not near as accurate as an actual gun, but better then a remote controller
http://www.radarbusters.com/laser-jammers/laser-accessories/handheldlasertester.cfm
roninmd
10-22-2010, 11:09 PM
never mind... I blew the controller module after shortening the front shifter cable while trying to fix the laser falsing @ 3000 rpm problem.
AirMoore
10-23-2010, 11:29 AM
never mind... I blew the controller module after shortening the front shifter cable while trying to fix the laser falsing @ 3000 rpm problem.
That sucks... and bikes are known to have big issues with noisy electrical systems, combine that with escorts known issues with laser falses on a noisy electrical system, and you need a good in-line filter...
Hope you can get it replaced, goodluck.
roninmd
10-24-2010, 12:20 AM
never mind... I blew the controller module after shortening the front shifter cable while trying to fix the laser falsing @ 3000 rpm problem.
That sucks... and bikes are known to have big issues with noisy electrical systems, combine that with escorts known issues with laser falses on a noisy electrical system, and you need a good in-line filter...
Hope you can get it replaced, goodluck.
Thanks for feeling my pain. I bought it off ebay so no warranty. Luckily a family member is an engineer. There was a blown mosfet transistor in the control module and a blown capacitor in the front shifter. He replaced the capacitor with a slightly larger one and used a larger MOSFET transistor in the control module. The MOSFET was large enough to take 12volts through it.
The shifters seem brighter.
Before blowing the control module:
http://www.youtube.com/watch?v=_oMig9E-pcA
After getting it fixed:
http://www.youtube.com/watch?v=w1RW8usj5OQ
If you have any broken zr4 or zr3s, I'd like to have them to experiment on.