PDA

View Full Version : Pics & Questions of Veiled HIDs/Fogs on BMW M3.



atwardiv
02-02-2006, 07:04 PM
Hey all, just wanted to post pics of my experience with this fine product and wanted to make sure that I applyed it properly.

1. Side View of Veiled HID.
http://i42.photobucket.com/albums/e330/atwardiv/Veil1.jpg

2. Left HID/Fog = Factory. Right HID/Fog = Veiled
http://i42.photobucket.com/albums/e330/atwardiv/Veil2.jpg

3. Top View
http://i42.photobucket.com/albums/e330/atwardiv/Veil3.jpg

4. Lights Off
http://i42.photobucket.com/albums/e330/atwardiv/Veil4.jpg

Question:

1. Granted I do not know how long it takes for Veil to fully set (these pics were taken 10-15 mins after application), but did I put on too much Veil on the HID in Pic #1? Is the haze/streaking normal?

brick
02-02-2006, 07:31 PM
For a first timer I think you did an excellent job. The first time I applied Veil it was much more streaky. As long as there is a moderate coat over the entire light you should have nothing to worry about. When the coating finally wears down (hopefully quite a ways down the road) you can shoot for perfection.

atwardiv
02-02-2006, 07:38 PM
I can't stand how it looks, I am going to remove it and try again. Is it better to make however many brush strokes it takes to cover it evenly and let it sit, or keep stroking it (no sexual reference intended) till it dries?

brick
02-02-2006, 07:58 PM
Have you watched Veil Guy's video? It's best to let gravity do most of the work. Start at the top with a well-loaded sponge brush and let it run down, using the brush to even it out on its way down. As it flows naturally the streaks will come out. Few brush strokes are better than more, and don't worry about drips. Just make sure that you have a rag handy to clean them up immediately.

It does take practice to get it perfect. Which reminds me, my headlights desperately need a fresh coat...

atwardiv
02-02-2006, 08:16 PM
Just ran down to the garage to get it off. I had no issue getting it off with Windex. I will rewatch the video and make sure I do a better job. Thanks for your help!

EastGermanOlympicJudge
02-02-2006, 08:18 PM
Question:

1. Granted I do not know how long it takes for Veil to fully set (these pics were taken 10-15 mins after application), but did I put on too much Veil on the HID in Pic #1? Is the haze/streaking normal?

It only looked good in the beginning because it was still wet. You didn't put too much on. The "haze" is normal. The streaking is just an artifact of a first-timer install. Use the foam brush, no more than one stroke over any spot. Start at the top, make horizontal strokes, and work your way down. Should fix the streaks.

atwardiv
02-02-2006, 11:51 PM
Gotcha, I will try again today and see how it goes.

Dilip
02-03-2006, 01:10 AM
it always looks goood in the beginning, but after a few hours thats when it doesnt look so good.

Pls let me know how your HID lights are afterwards.

Mackid343
02-06-2006, 04:31 PM
it always looks goood in the beginning, but after a few hours thats when it doesnt look so good.

agreed, i loved the look right after i put it on, but now it makes the lights look dull rather than darker and meaner

stealthJamal
02-06-2006, 05:43 PM
I've never been able to apply Veil very well, every time I try it looks like $hit. For a first time attempt you did a better job than I could have done. I've seen TheVeilGuy in person apply Veil several times and the job he does is amazing.

atwardiv
02-06-2006, 06:53 PM
I guess we need to fly him out to the east coast and do a group application. :)

stealthJamal
02-07-2006, 08:57 AM
TheVeilGuy is in PA

happya$$
02-07-2006, 09:51 AM
I've never been able to apply Veil very well, every time I try it looks like $hit. For a first time attempt you did a better job than I could have done. I've seen TheVeilGuy in person apply Veil several times and the job he does is amazing.

This is a technique that I have never been able to get down myself. Sethy came close on my wife's SUV. Bob has it down pefect

TeamQuack
02-07-2006, 03:06 PM
i just got my can and im waiting for the right day to put it on.

how long does veil take to settle? from the video i see it very viscous and then slowly turn solid, how long does this process take (basically how long after you freshly apply it can you stroke on the veil until its ready for you to leave it to settle)? the reason im wondering is because im trying to get this technique down, i figure as time is running out (as its becoming firm) you have to pretty much be done stroking and having it settle down on itself to remove the streaks. so does anyone know?
and also how much does using a hair dryer help? im figuring the air might cause some lumpiness.