ive been going past speed signs and every time i pass them i get a different frequency on spec mode. why does it not give me the same reading every time?
ive been going past speed signs and every time i pass them i get a different frequency on spec mode. why does it not give me the same reading every time?
depends how long since they have been tuned they fall out of tune as time goes by thus giving off diffrent frequencies I think
you'll never get the 'exact' frequency.........radar detectors are far to small to be 100% accurate for this
what you do get is usually good enough to make a decision for yourself though
i went passed the same sign 3 times and got 3 different readings
k 24.143
k 24.162
k 24.114
I would think they would be a little closer?
I had a question related to this... but rather than start a new thread I'll ask it here. Using spec mode (or expert, not sure which one)... can you readily distinguish between a door opener and a k-band radar gun? Are the frequencies usually different enough or not?
I will explain for both.
1- Frequency’s drift as some have said.
2- There are more than one false (in/out auto door sensor) additional auto doors & alarms.
3- Spec mode is not perfect/right on the money.
4- Spec mode is broken down into blocks of frequency so there can be big jumps, however its more likely because of #2.
K band LEO radar is exactly 24.150 and some doors are as well, so Spec mode will help but not in every case.
no did get all 3 flickering back and forth. those 3 frequencies i wrote down were solid until i went passed the sign, after i passed the sign it changed but i no thats normal. im just wondering the drop from 24.162 to 24.114 seems like a big difference. and i no spec mode is not a 100% but just thought the same sign would put out close to the same frequency.
Bookmarks