RX65 VERSION 3.6

[cavili]

self calibrated my rx65 with a miniature screw-driver and yields better sensitivity and performance. bought from radar roy, owned for almost 3 yrs service require displayed once. so far so good just love it.

regards
derence
SINGAPORE

[philnz]

please explain
is there adjustable screws inside
how did you do it

[bauzer71487]

please explain
is there adjustable screws inside
how did you do it

I wouldn't recommend it dude. Unless you know what you are doing - tighten too hard and you could make it an expensive paperweight or windshield ornament.

[jimbonzzz]

Sounds like trouble to me...

[alias3r]

how do u do something like that? in detail explain how u did it.. also, why dont the companies just increase sensitivity right off the back? or will it false more?

[cavili]

how do u do something like that? in detail explain how u did it.. also, why dont the companies just increase sensitivity right off the back? or will it false more?

Remove the back cover of the horn antennae and there is a potentionmeter - (not sure the correct name) and with a miniature
flathead screw driver to turn anti or clockwise but patience is very much
needed to tried out at several point of locations.

[Toronto-radar-chopper]

Interesting if you control frequency sensitivity. It was never clearly explained if I enable POP band will sensitity be increased against the 33.8Ka band range and reduce others.

[cavili]

Interesting if you control frequency sensitivity. It was never clearly explained if I enable POP band will sensitity be increased against the 33.8Ka band range and reduce others.

without the proper equipment, lots of trial & error inorder to determine the best sensitivity. My only advice is be very careful whilst turning the miniature screw - do not force the screwdriver on it and turn it slowly and carefully. Honestly, I've done it successfully and I post it on this forum to help those who encounter such problem likes service required.