Jammer install - Dodge SRT

[srtga]

mrcllusb and I installed his RX75 on my car this weekend. This is what we came up with.

I'll probably go back and re-level the heads and tinker with it some more. The ZR3 heads don't have parallel sides so I'll have to think on it.

The blue is the radar antenna.

Blake does alarm installs so the RD install went really well!

[trailtow]

very nice install now running arrows in spec mode

[snoopyc4]

Nice install

[trailtow]

are those little black things near the jammer heads deers siren things do they even work or just a cheap piece of junk from autozone

[mrcllusb]

Once we decided on the layout,the rest was cake.If any of you guys are in or near Savannah and need help with your install just give me a holla.I have all of my own tools.I know when i worked at the install shop we charged about 45-50 an hour,for just labor.So if i can save you a few i'm willing to.

[srtga]

are those little black things near the jammer heads deers siren things do they even work or just a cheap piece of junk from autozone

I don't know if they work but I figure it won't hurt Deer are a real hazard on a lot of the roads I run.

Yep, I recommend Blake highly. No crimp on stuff for him. ALL soldered, well secured, wires hidden!

[MEM-TEK]

Installation looks good! I had those deer siren things on my old car, but took them off when the sound they made startled a deer which then ran right out in front of my car. I missed hitting that deer by less than 1 foot and the encounter scared the living daylights out of me. Later that evening I yanked those deer siren things off my car.

[speed-dreams]

just curious, how yall solder wires while in the car? I asked because there'S no where to rest the wires on...

are those little black things near the jammer heads deers siren things do they even work or just a cheap piece of junk from autozone

I don't know if they work but I figure it won't hurt Deer are a real hazard on a lot of the roads I run.

Yep, I recommend Blake highly. No crimp on stuff for him. ALL soldered, well secured, wires hidden!

[mrcllusb]

Whatever connection i can solder and heat shrink out of the vehicle i do.The wires i solder in the car are ignition,12v supply.First i look up the wiring diagram for the vehicle.See where the ignition and or accessory wires are and what polarity they are.Use my multimeter( Not Test Light)!! to check for ignition switched 12V line.Use my soldedeing iron flat tip to melt insulation away in a small area,use my point tip to poke a even split between the wires,stick the new wire thru the split,wrap around clock wise then solder and tape using good 3M super33 electrical tape.Solid connection that will hopefully never come apart unless you make it.

[SpdFreak]

Installation looks good! I had those deer siren things on my old car, but took them off when the sound they made startled a deer which then ran right out in front of my car. I missed hitting that deer by less than 1 foot and the encounter scared the living daylights out of me. Later that evening I yanked those deer siren things off my car.

Did it ever dawn to you that your head lights, or someone elses caused the deer to freeze?