As you can see, CB is located right next to my vent. Should I worry about moisture build-up when bi-level AC is on? Also, will heater also affect the control box?
![]()
As you can see, CB is located right next to my vent. Should I worry about moisture build-up when bi-level AC is on? Also, will heater also affect the control box?
![]()
I doubt it will be a problem, if heat is blowing directly on it from the vent then it may cause problems with heat buildup. But unless it is blowing directly on the control module I think you should be fine.
If it's just sitting on next to the vent and you are worried, cut you a thin piece of styrofoam to go between the control module and vent to provide insulation.
Valentine One (3.858 Ice Cream Truck, 3.812 in Vette)
4 Head LI (On Vette) (7.11 CPU Regular heads front, HP Heads on the rear)
9500ci (On Vette)
LI Quad (On Ice Cream Truck)
LI Dual (On SRX, 7.06 CPU)
ProLaser II, ProLaser III, Stalker LZ-1, LTI Marksman & Laser Atlanta "R" (looking for an Ultralyte LRB)
2008 Corvette Z-51 Coupe
Escort 9500 ix (Cadillac SRX)
You can use superlock strips to attach it somewhere else...
Bookmarks