PDA

View Full Version : LI bad connection to sensors



suicidal4life
09-24-2008, 02:42 PM
Installed my LI about 2 months ago. Maybe about a week after installing it I got a "bad connection to sensors" (or something similar to that) at startup. Actually the radio was turned up pretty loud so I didn't really make it out completely but it startled me. I turned the LI off and back on and it gave the normal "welcome" I shrugged it off and forgot all about it until last night. Last night I'm leaving the local supermarket and start up the car and hear "bad connection to sensor". Once again I switch the LI off and back on and "welcome". I've switched the LI on and off maybe a dozen times since then with no problems. Is it normal for the LI to occasionally (every couple months on a daily driver) give a bad connection warning or is this something I need to worry about?

I probably should have searched before asking but I'm feeling extra lazy today :rolleyes:

Laser-InterceptorUSA
09-24-2008, 02:45 PM
This is normal and associated with the low voltages being supplied to the LI's Processor in the CPU at start-up!:)

Cliff - C55

suicidal4life
09-24-2008, 03:57 PM
Thanks for the speedy reply Cliff. Good to know this is a normal "glitch" for lack of a better word.

Laser-InterceptorUSA
09-24-2008, 03:59 PM
My pleasure!

Cliff - C55

Darkflame
09-24-2008, 05:23 PM
I've had that before on my bike when I had my LI, Low beam HID and High beam HID firing at the same time.

You can resolve that with a dei-528t relay if it becomes a nuisance. That's what I did.

Now when I turn on the ignition, 5 seconds later the LI will say welcome, 5 seconds after that the HIDS will fire.

Puts less stress on the electrical system. On a car I doubt there's a problem with stress but on a bike, if you got too much going on at once the battery's voltage drop could stress the battery when it comes time to crank the engine. Now with this setup, once I turn the engine on and the voltage from the stator rises, the draw on the electrical system is stabilized before all the high powered electronics start firing.

corkguykev
09-24-2008, 06:08 PM
i have a kill switch for my V1 and i dont switch it or my LPPs on until the car has been running at least a few seconds to save them from the voltage changes that occur during start up.

same goes for my onboard camera system

crazyVOLVOrob
09-24-2008, 07:19 PM
i have a kill switch for my V1 and i dont switch it or my LPPs on until the car has been running at least a few seconds to save them from the voltage changes that occur during start up.

same goes for my onboard camera system
Well I don't have a kill switch for my detector but I hardly ever turn my jammers on until I am leaving the parking lot or driveway

focalcivic
09-24-2008, 07:25 PM
Just in case check to make sure the RJ's did not come loose from the control box.

TSi+WRX
09-25-2008, 10:33 AM
BTW, don't forget the obvious! Check your connection. :)

Remember, these are road-vehicles, exposed to lots of vibration and impacts.

That connector really can "just come loose." :)