how do you check the revision number on the RX-65?
how do you check the revision number on the RX-65?
Power up the unit while holding down the 2 other buttons. It will flash the version and go to default settings
Specifically hold down City and Brt while powering it on.
well ihave rev 6.1 so that sounds good..... but performance wise i am not impressed it doesn pick up a k band speed sighn until you r about .2 miles from it where as the V1 and X50 where almost a half mileOriginally Posted by cdilln
One thing that hasnt been examined closely is the variation of performance of individual units of the same model. It's possible you have a lemon.
But, I think you need to make your comparisons within the same time frame with multiple runs. Could be some variable at work you're not aware of.
Right I gotta say Belscorts QC really sucks, like my X50 Rev 5 Blue outperforms my Buddy's X50 Rev 5 Red by a bunch
am ithat stupid..i cant get it to display the number..ayyyyyyy
i have only had the detector for say 10 hours and i am not impressed so far but i still have four more weeks.... my girl likes the V1 best, but likes how the X50 is a lot quieter and doesn like the Rx-65 cuz it is to quiet lol
Everyone loves the V1........I liked it when I tested it next to my X50 (Outrun's V1, I think it was a 3.826 at the time) and I liked it, but it didnt do much better than the X50 in forward detection, and I had to actually LOOK at the display to tell whats going on (Sure its partially because thats the 1st time ive used one, but the LEDs are a bit scrunched together, its alot of data, which is good, but its not very organized, which is bad..another thing about Valentine that I liked was that the display was easily visible in direct sunlight, I guess because the LEDs are bigger thus capable of more power and the resulting light outputOriginally Posted by Bear-Tweezy
The X50 is certainly quite possibly the quietest RD there is due to its excelent filtering vs all the others (Really this is a double-edged sword....its good and bad)..........and the X50 also has good Laser compared to the RX-65
as I said before the Quality control of Belscorts is seriously lacking so you might have a bad RX-65 (But I have personally seen more variance between different RXs as opposed to different X50s)
If your V1 and X50 are reporting in at half a mile on k band and your RX65 only .2 Something is definitely wrong with your RX65. It should alert right around the same area as the other two. Send it in
Bookmarks