Okay... so I guess I got owned (as predicted).Originally Posted by SmaartAasSaabr
So what keeps any waves from leaking? I thought it was the magnesium case.
Okay... so I guess I got owned (as predicted).Originally Posted by SmaartAasSaabr
So what keeps any waves from leaking? I thought it was the magnesium case.
It's the antenna design... in effect the frequencies of the LOs make the waves larger than the holes in the antennae where the higher frequencies (thus smaller waves) of the radar being detected can flow in. That's how I understand it, but it also uses various other technologies to reduce the "power" of the LO as well.
One BIG contributor to the STi's stealth is the LNA's (Low Noise Amplifiers) in the front end. These provide good reverse isolation, letting radar in, but preventing anything from leaking out. Before the STi's release, the only detector that used these LNA's was the V1, which explains why the V1 did magnitudes better than all other detectors against the Spectre (before the STi, of course). In the STi, the LNA's take care of most of it, while the waveguides and other filtering take care of the rest.
What if you added loads of LNA's obviously each amplifier would lower the signal and reduce leakage.
How many LNA'S would it take to lower the signal completely..
Hard to say. Even with multiple cascaded LNAs preventing leakage from the circuit itself, it seems to me that there would still be some "open air" leakage from the LO which would require the waveguide filtering as used in the STi. There might even be some technical problems with using cascaded LNAs that I am unaware of.Originally Posted by laserblaster
Bookmarks