Bel RX65 problem

**JordanDawg05** · 05-21-2007, 05:52 PM

hi all,
I just bought my RX 65 about a week ago and i have a problem with it. i am still not famiar with the detecotr but on start up it says LASER then gives x off, ka off...etc. What should i do? i am not sure what happened but its not picking any signals as they are 'off' but how can i reset?

Any help is appreciated on this matter.
Thanks!

**carter840** · 05-21-2007, 05:57 PM

you need to reprogram it. First off on start up it is supposed to say stuff like laser and then run through all of the bands. But if you want to turn on bands or turn off bands you must go into programming mode. To do this hold down the city and bright buttons together and you will be in programmig mode. All of the information you need is in the instruction manual.

**MEM-TEK** · 05-21-2007, 06:09 PM

*****

**Sparkknocker** · 05-21-2007, 06:29 PM

Read the manual! You will be amazed at what you can find in the text of a book

**JordanDawg05** · 05-21-2007, 07:34 PM

Hi guys,
Thanks for the quick reply. I was able to set the bands i want to as advised and it works. The odd thing i can't figure out is why this happened? i never set any thing or played with it but this mornign this happened so it freaked me off a bit. It keps saying LASER that flahsed several times and the bands were off. I did have my RD go off with LASER yseterday but would this have caused the RD to turn bands automatically?

Thanks for the help !