Bel RX65 Problems

[Samdogg1]

For the past 2 weeks my bel has turned a lil crazy. In the morning i would go and turn it on, it would run through the startup then 5 secs later x or k band would alert at full blast and wouldnt stop till i turned it off. But i noticed once it warms up it does fine. So this morning i went to turn it on ran through the startup, then it went x off k off ka.....i turned it off and on again to my surprise i cannot program it anymore and it defaults to the voltage indicator on the screen. It will not pick up any radar at all now, also when i try to proram it, it says program then it beeps at full alert for about five seconds till it goes back to the voltage display. Has anyone had this problem before? Does it need to have the version downloaded again? Oh yeah i have only had the detector for five months now.....

[MEM-TEK]

First, do a factory reset by holding down the two program buttons and then power it up using the power button. Hopefully you will see the "reset" message. Don't try to go into program mode after it is powered up. If it still produces random or continuous alerts then it will have to go in for service.

[Samdogg1]

Thanks MEM-TEK I reset the detector and it seems to be working fine now. I also saw version 6.3 pop up is this the latest version?