I just got my x50 hard wired high and the cheap cups make the detector sag. Where I really want to mount it has the dots which is closer to the rearview mirror. Can the super cup hold under the dots? Ready to kill my cheap cups...again
I just got my x50 hard wired high and the cheap cups make the detector sag. Where I really want to mount it has the dots which is closer to the rearview mirror. Can the super cup hold under the dots? Ready to kill my cheap cups...again
i put mine there and it works fine... if the cup wears out boil them for 30-60 seconds then dunk them in cold water they should go back to the original form
take a small piece of 600grit wet/dry sandpaper to the dots just to scuff a little or a single edge razor to get the shine off the painted dots .Same thing i do with window tint it works!
I could not get my suction cups to stick to the dots. There are some good suggestions here to try though.
One thing I would not do is mount the RD behind the dots. I have reason to believe they may affect radar reception.
GTO_04
The dot want effect the radar.
I used a glass plate over the dots with double sided clear tape, but i would suggest a plexiglas plate the first time.
![]()
Piece of clear packing tape.
The problem with the dots is that they are raised enough so that your suction/vacuum from the cup leaks out and it eventually falls off. Clear tape should allow it to seal better.
I'm not trying to make my cheap cups work. Just weather the super cup will mount behind the dots. My RD won't be behind the dots but I want to mount a super cup behind the dots. My cheap cups make the x50 sag and not sit level with the road
oooo if ur using the cheap cups what slot are u putting it on sometimes u have to put that clip in all the way for it to be level
Bookmarks