Redline and Laser hits

**Woodscolby** · 08-04-2011, 04:10 PM

Originally Posted by EscortRadar

Originally Posted by Woodscolby

My Redline is so good at detecting laser that it goes ahead and alerts to it even though I have the laser detection option turned off...

Only during the first few seconds after power on will the RedLine alert to laser with laser detection disabled.

Had been on for approximately an hour... It does this at every single jammer testing meet and I have had it happen in several laser encounters on the road:

**switch626** · 08-04-2011, 08:10 PM

I'm with Woodscolby on this. I have always had laser off on my Redline until I realized that it will alert with my Blinders then laser is on. When it is off, there is a very obvious lag. I have several examples where there is no mistaking it.

For comparison, here is a recent encounter with laser turned on on the Redline.

**insidercw3** · 08-05-2011, 07:24 AM

My Redline doesn't behave this way. When I program LASER OFF on my Redline the laser detection is disabled and it stays disabled.

So what are you guys doing that is different?

**switch626** · 08-05-2011, 08:28 PM

Originally Posted by insidercw3

My Redline doesn't behave this way. When I program LASER OFF on my Redline the laser detection is disabled and it stays disabled.

So what are you guys doing that is different?

Good Question! Here's my configuration

Expert Mode (I'm not one, but I like to feel like it, lol)
Automute = off
SWS = off
TSR = on (It was however off in some of my videos with the lag too)
X Band = off
K Band = on
Ka Band = on
Laser = off (during the first videos, on now with no lag)

Also, I am always in highway mode.

**insidercw3** · 08-06-2011, 06:09 AM

I tested my Redline with those exact settings and with the Laser programmed OFF, it is off after about 5-10 seconds after power up. Perhaps you should revisit this issue and check again.

**switch626** · 08-06-2011, 06:18 AM

Originally Posted by insidercw3

I tested my Redline with those exact settings and with the Laser programmed OFF, it is off after about 5-10 seconds after power up. Perhaps you should revisit this issue and check again.

Thanks for taking the time to test this. Your result tells me there is something wrong with my Redline. Not that it matters much, since the I'm still very happy with the radar detection. Should that change, I'll send it in to Belscort for repair.