2010 Jeep SRT8 Mounting Thoughts

[Warz00]

Ideas for mounting 2 heads - and do you think 2 is enough?

Going with either LI or M27'sjeep_10grandcherokeesrt_frontview_Large.jpg

[radarrob]

PM sent

[Stealth Stalker]

Two LI heads will cover your front. Two Blinder heads will not. Either way, your tail is still wide open, so don't wait too long before getting two more heads!

[Warz00]

Thx. As far as I am aware they have not been shooting from the rear yet in the NY/NJ/DE/MD area but I'm sure it's coming even if that's correct!

If I go 2 LI, where do you think is best to mount?

[Laser-InterceptorUSA]

Here are my recommended installation locations for your LI Sensors. Yes, you have fog lamps which would normally mandate a lower install position in the grill but the additional vertical height of your SUV requires that exposure be addressed.



Cliff

[ny450es]

and where would you mount the rears?

[Laser-InterceptorUSA]

Here are my recommended installation locations for the rear.

Cliff

[DrCoke]

Thx. As far as I am aware they have not been shooting from the rear yet in the NY/NJ/DE/MD area but I'm sure it's coming even if that's correct!

If I go 2 LI, where do you think is best to mount?

I'm sure they ARE shooting from the rear but you never got a warning from your radar. Do it right and buy a Quad system.

[Warz00]

ok here is the install

[Stealth Stalker]

Oh man, nice! What a great fit! Front and rear both look good. If you have any problems at all on the front that can't be fixed by re-levelling and alignment, then you might want to try turning the sensors inboard. But I think you'll be fine as is.