Checking Software version

[Python]

How do you check your software version in the V1?

I read on the V1 page,

"Press and immediately release the Control Knob to display software version. The software-version number is four digits that display one digit at a time in the Bogey Counter-example: 2.869"

but this didn't work for me. I also noticed that pushing the Control Knob mutes the alert so maybe when I press the Control Knob, it is just muting.

Thanks

[jimbonzzz]

I. How to enter the Programming Mode.
Starting with the Control Knob in the "off" position, Press and hold-in Knob and at the same time turn the Knob “on;” continue holding in the Knob until all front-panel lights are on (takes about 5 seconds).
Release the Control Knob.

II. How to determine your software version.
Press and immediately release the Control Knob to display software version. The software-version number is four digits that display one digit at a time in the Bogey Counter-example: 2.869.
Note your software number, then see the table below for features that are programmable in your unit.
Press and immediately release the Control Knob to exit software-version display.

[Python]

Thanks Jim,

That was it ...

Jim