V1 All Band Sweep Time?

[Mr Q]

Does anyone know how long in seconds the V1 takes to do a complete sweep (factory settings) of all the bands? I'm debating shutting off the X band if no one uses it where I drive. If I do, what time would I gain in sweeping just the other bands ?

[RedRocket]

Hundreds of milliseconds IF no alerts occur causing a "latch" holding for several seconds on a received radar signal.

[Mr Q]

Well, if a 100 miliseconds equals 1 second, then I assume you mean up to a few seconds for each complete sweep of all bands?

[RedRocket]

^ Incorrect !

A millisecond is 1/1000th of a second.
Therefore 1,000 mS = 1 second.

[Buckdarma]

what i have heard is most detectors scan at the 240 millisecond range. Of course this isn't for the segmented models

[Mr Q]

^ Incorrect !

A millisecond is 1/1000th of a second.
Therefore 1,000 mS = 1 second.

You are correct. My old age is showing its signs So considering, that's pretty fast unless you are doing a hundred - then tenths of a second starts to become important. I have a Pocket Radar and after several tries, the detector alerts within a couple of tenths of a second or faster

[Mr Q]

^ Incorrect !

A millisecond is 1/1000th of a second.
Therefore 1,000 mS = 1 second.

You are correct. My old age is showing its signs So considering, that's pretty fast unless you are doing a hundred - then tenths of a second starts to become important. I have a Pocket Radar and after several tries, the detector alerts within a couple of tenths of a second or faster