Feedback on LI Install

[noTe]

x2 bubbles out

Laces out Marino!

[hockey005]

lol

[DarkChewby]

yea I am going to do bubble out. No no infinit did it like 8-9 times in. I also got it parked. I also got reigal alerts 1 day about 3 hrs of driving. Unless all I am doing is driving behind infinitis lol.

[speed-dreams]

yea I am going to do bubble out. No no infinit did it like 8-9 times in. I also got it parked. I also got reigal alerts 1 day about 3 hrs of driving. Unless all I am doing is driving behind infinitis lol.

Do get your setup tested... You might get away with bubbles in...

[Stealth Stalker]

Sun interference maybe?

[takeshi]

My LI did the same thing when one of the heads was defective. It would constantly alert to Traffipatrol XR.

[category4]

One of my heads did that to, it was the sun causing it. Cliff sent me a new head and all was good.

If you take a regular incandescent flashlight and shine it into the receiver bubble at night you should get a sun interference alert. A LED flashlight does not work. This might help you narrow it down to which head is bad (not giving a SIA).

[sonny03106]

I used to get "Rigel, Jamming sequence is activated ......". I started getting this error 2nd day of the install. I disconnected on head at a time and drove for a day. I found out that one of the heads in the back was defective. Cliff sent me another one but turns out that the cable was too short and they had to make a custome made (LONG cable for me). It took couple of weeks but I got the head few days ago. I am going to install it next week.
I think you should start disconnecting one head at a time and find out which head is bad.

[speed-dreams]

I used to get "Rigel, Jamming sequence is activated ......". I started getting this error 2nd day of the install. I disconnected on head at a time and drove for a day. I found out that one of the heads in the back was defective. Cliff sent me another one but turns out that the cable was too short and they had to make a custome made (LONG cable for me). It took couple of weeks but I got the head few days ago. I am going to install it next week.
I think you should start disconnecting one head at a time and find out which head is bad.

A good way to check heads is using an IR camera and check if they fire, or if you see moisture in them.

[DarkChewby]

thanks :P I am def going to try out those solutions to see which one of the heads are defective.