Is it safe or advisable to tap the same wire twice for power to the detector and again for a remote speaker?
Is it safe or advisable to tap the same wire twice for power to the detector and again for a remote speaker?
Should be fine as long as the fuse on the wire you’re taping is ample and you do a good job.Originally Posted by denaliman
Don't upgrade the fuse, keep it stock. The reason is that if you try making it a higher amp fuse, it'll probably burn up your wiring harness instead of blowing the fuse.
I've done that on a couple installs. Since the power draw of both the detector and the speaker are very minimal there won't be any issue at all.
Thanks for the replies. I am not lazy to find another wire. My vehicle is new and there really is not much where I can tap from that is a 12V switched. I plan on tapping the lighter 12V which is a 20A fuse line.
I agree with the others. I just want to reiterate what CJR238 said about the original fuse. Make sure you keep the same amp fuse in place. The purpose of the fuse is to blow if the current gets too high. This prevents the wire from burning. Never replace a fuse (or a circuit breaker) with a higher amp fuse unless you are absolutely certain the wiring can handle the higher amps. If you tap into this wire, and find the fuse keeps blowing, then you need to tap a different wire. But I think you will be fine.
Bookmarks