I know when you want to program K band muting you can choose the seconds etc.
My question is this for settings E (Unmute at 4 lights) and F (unmute at 6 lights) do you have to choose one or the other or choose both?
I know when you want to program K band muting you can choose the seconds etc.
My question is this for settings E (Unmute at 4 lights) and F (unmute at 6 lights) do you have to choose one or the other or choose both?
One or the other. I think.
the wording is a little confusing. option E controls muting at the onset of the encounter. option F controls muting after the initial signal is picked up. If E and F are up, any signal that starts out at less than 4 lights will be muted until it gradually climbs to 6 lights, at which point it will unmute. If E is up and F is down, the same signal would remain muted all the way to full strength. However, if the initial reception of the signal was 4 lights or greater, it would be full volume. If E and F are both down, there will be no mute override of any k band signal until the mute time defined by b,c and d has elapsed.
F arrow down will automute 8 lights as well but the signal must come on gradually.
When using E & F together in big L mode K band is basically dead or turned off for the time limit.
E & F together is not in the programming instructions but I have nick named it "all surge" mode.
I know, i said that in my earlier post. E up , F down should be muted all the way to 8 if the signal started at less than 4, and be unmuted if it started at 4 or greater based on the E setting, in that case F wouldn't come into play.
I have to say, i really don't get the usefulness of Big L, might as well just run little L with the mute vol down, at least that way you still get the visuals.
Bookmarks