Pulse

[Michael B]

Needs to be no alerts for 20 seconds.
Needs to see a level 9
Needs to be in POP ON to see the word PULSE

The unit responds to Pulse type signals in the POP OFF mode but it will not display PULSE in the POP OFF mode.

In POP OFF it will just show a level 9

[cooljay]

Needs to be no alerts for 20 seconds.
Needs to see a level 9
Needs to be in POP ON to see the word PULSE

The unit responds to Pulse type signals in the POP OFF mode but it will not display PULSE in the POP OFF mode.

In POP OFF it will just show a level 9

Thanks Mike, always there with an answer when something comes up! Didn't know POP needed to be on for PULSE to be displayed

[MEM-TEK]

Alrighty! I tested my Pro78 against my X and K transmitters, triggering the transmitters just like I/O, and couldn't get my Pro78 to display PULSE. I tried with the transmitters fairly close to the Pro78 to produce X and K signal strength readings of anywhere from 7 to 9, and tested with my transmitters pointed towards the sky in order to produce signal strength readings of 1 to 3.

Note, however, that my X and K transmitters are not police radar guns and are instead just simple Gunn oscillators powered by voltage regulators. Thus these transmitters do have slight frequency drift during the first few milliseconds after being powered on, and it is possible that this slight frequency drift is why I couldn't get my Pro78 to display PULSE.

[jdong]

Needs to be in POP ON to see the word PULSE

The unit responds to Pulse type signals in the POP OFF mode but it will not display PULSE in the POP OFF mode.

In POP OFF it will just show a level 9

Aha! That explains it; didn't know that requirement.

[Jag42]

Needs to be no alerts for 20 seconds.
Needs to see a level 9
Needs to be in POP ON to see the word PULSE

The unit responds to Pulse type signals in the POP OFF mode but it will not display PULSE in the POP OFF mode.

In POP OFF it will just show a level 9

I was wondering why i never saw PULSE ! I never ran pop ! Good Info.