
Originally Posted by
Curti

Originally Posted by
Lucky225

Originally Posted by
jmccam

Originally Posted by
Lucky225
Got the STi-R back from BEL, it was the EXACT same issue at last time, power supply burnt out. I guess running all my electronics on the same POSITIVE wire probably isn't a good idea, or starting the car with those units ON can cause the current on that wire to fry some of the electronics. In any event, I'm still running everything on the same Positive wire now, but in addition I wired the STi-R to the Blinder Switch, so I will NOT turn on my countermeasures until AFTER the car is started, and turn them off prior to parking. I hope this will save the precious equipment

That is strange. The in-line fuse should be popping before this happens, thus preventing any surge of power to the unit.
At least you have it back.
Been running mine for two weeks now since getting it back and it is working fantastic. It is destroying my V1 on K band detection and staying ahead of it on KA hits as well.
Very pleased.

That's what I figure, but it it must be allowing a certain amount of VOLTAGE through before the AMPERAGE reaches the 2AMP range for the fuse to blow, cus the fuse DOES blow, it just doesn't save the power supply BEFORE it blows.. and the techs said if I have it hardwired ALWAYS ON and not on SWITCHED voltage, when I turn the key to start the ignition, that's probably when the surge is blowing it out. Since my car doesn't have switched voltage, I just wired it to the Blinder on/off switch and will manually turn on from now on AFTER I start the vehicle.
A very interesting problem. If I read this correctly, your LJ's and STIr are using the same hot wire from the power source. Is this switched power? In other words are (were) they on when the car is shut off? There are vehicles with two power recepticles (cigar lighters) one is switched one is not. If say for instance an RD were plugged into the unswitched power source it would be subjected to the starter motor draw and the alternator coming on line which would be a momentary power surge. Ok to leave the cell phone plugged into but not your RD. I find it difficult to understand why powering the RD & LJ's from the same power source would fry the STIr.
Yea, the power source for everything is on the same hot wire, and that hot wire is NOT a switched source(except that it is wired to the blinder switch), previously I had the STi-R wired in series, BEFORE the Blinder switch, so the STi-R was ALWAYS subject to the hot wire, and I would turn it on/off from the on/off on the control for the STi-R. Now, I've wired it to the Blinder Switch directly, so that you must physically flip the switch to connect the hot wire and turn the device on. The problem initially was no switched power source is available in my car(The cigar lighter in the REAR to the car is "switched", but even the it remains on for 10 minutes AFTER the car is turned off, so it's not a true switched power source, nor easy to tap into) The other problem as my ground is in the rear of the vehicle, so that's where I just put the hot wire in series with the blinder hot wire, instead of stripping it and running it all the way back to the front, which is what I've now done. Now that it's on the Blinder Switch I believe it should be fine as long as I don't flip it on prior to starting the car, and/or forget to turn it off when I park. It's much more convenient anyhow as holding the power button on the STi-R to turn it on usually takes a good 20 seconds, whereas with the flip of the blinder switch to on now takes it on, and turning blinder switch off turns it off. Much better

Bookmarks