Unfortunately, this is simply not true.
You have tons of more or less "inductive" loads (e.g. motors, coils etc.) in your car. Switching on and off these inductive loads at high currents will induce a very high voltage into the circuit, even so high that sparks on the switches are generated.
You can perfectly see this effect if you add a battery jumper cable or if you remove the contacts of your battery. As you might have guessed, the 13,8V of your car's battery is not sufficient to generate a spark..."When a strongly inductive load such as an electric motor is switched off, the current cannot drop instantaneously to zero; a spark will jump across the opening contacts. Switches for inductive loads must be rated to handle these cases. The spark will cause electromagnetic interference if not suppressed; a snubber network of a resistor and capacitor in series will quell the spark."
(taken from - in this respect quite amateurish - US-wikipedia, Switch#Inductive_loads - sorry, cannot post links)
A spark is triggered when the electric field strength exceeds approximately 4–30 kV/cm
(taken from US-wikipedia, Electrostatic_discharge#Sparks - also valid for sparks generated by induction)
You are referring to motors and capicitors. Capicitors do store voltage until drained. You are correct that you can get a very high voltage. The battery is really to help the starter, then the alternator takes over for your power. However in this application, you should not see anything higher than the 14 volts if he is on something like his radio circuit. Yes you do get a very high voltage from the plugs and coil to start the engine.
Last edited by Matt; 04-01-2010 at 06:30 AM.
Where is MEMTEK!!!He could probably sets everyone straight. He probably already has the answer to this mystery
When in doubt, read the manual. The installation manual says to connect it to switched 12V.
MEMTEK has been on hiatus for quite some time. I think he works for Escort now on how to build a better ZR4!![]()
One could only hope![]()
Bookmarks