Sorry for the delay, I posted a reply from my blackberry but I think it got lost in the net somewhere. LOL!
Ok simply put, the LI (at least my revision) used a tda7052 amp to drive the speakers. If you google the data sheet on that amp, you'll read that it's a BTL amp. It also states not to ground either pin or you'll fry the chip.
BTL uses both negative and positive voltages to drive the speaker. Single ended output uses positive voltages to drive the speaker and a ground for commons. It drives the speaker in both directions using positive and negative voltages. More bang for your voltage dollar.
Now if you ground a pin, when you drive the speaker you're just grounding out the chip which will eventually burn itself out.
What you need to do is determine how you want to tackle the situation.
You can drive an external speaker if you like and it will sound great!, all that I am saying is before you start soldering jacks to the LI to be cautious of the plug you are soldering and make sure nothing get's grounded. The plug in the LI is pretty solid and secure and none of it's pins protrude so you don't have to worry about anything shorting there. However, soldering your own plug for ease of plug and play (I am assuming this is the reason) just be careful that the ease of plug doesn't become the ease of unplug either. My philosophy is ground is common on a car, it's meant to be everywhere and if a wire somehow makes its way loose it will find a ground to latch on to. Just a murphys law of electronics IMHO.
To avoid this process you convert the BTL audio to single ended. You can do this by wiring inline a 1:1 isolation transformer.
In my bmw I have a inline 1:1 transformer wired within the cpu box and the leads are then integrated into the bmw's onboard sound system via the amp.
Here's a vid if you want to take a look.
YouTube - Laser Interceptor Install on a 1997 BMW 540i
Enjoy!




Reply With Quote
Bookmarks