Radar detectors in Europe. Please help!!!

[Crash]

For laser it is a no brainer get the Blinder and a can of Veil

The Blinder does not give off any jamming codes that I am aware of and it will jam and notify you when you are being hit with laser.

http://www.radarbusters.com/products...er/default.asp

The Veil will also bring down the reflectivity of a laser gun down, helping you avoid the laser traps:

http://www.radarbusters.com/products/coatings/veil.asp

As far as the RX65, Beltronics does not allow the transhipment of this unit outside of the USA. However they do allow export of the V995. For use overseas, this would also be a better choice as it is not programmed for the US Ka bands.

http://www.radarbusters.com/products/beltronics/995.asp

I second what Roy said. If jammers are illegal in Denmark just make sure it stays well hidden and you shouldn´t have a problem. And DON´T try to show off and drive right past the cop at full throttle, they tend to dislike that 8)

[BiGeAsYgUy]

Isn't the Blinder made in Denmark?

[peter]

I have just found out that Denmark produces Blinder M20!

I have this car:

I do not think that I can install Blinder M20 between the lights, because there is not enough place. Can i install it between the fog-lights (see the picture)? But I do not have fog-lights. Is it a bad idea to install M-20 there?

I have read the instructions of M-20. Many wires go to one little box. And from the box goes one cable to inside the car. But how shall I do that? Is there a hole between the inside of the car and the motor?

I am sorry if these questions are too stupid. I have never tried it before.

[Crash]

You can either install the heads in the grill (between the headlights) or below the license plate (between the fog lights). Just make sure it´s close to the license plate. If you have trouble installing it, take it to an audio shop, they´ll install it for you. Btw, the one that doesn´t know but doesn´t ask is stupid, not the one that asks.

[SETITOFF]

You can either install the heads in the grill (between the headlights) or below the license plate (between the fog lights). Just make sure it´s close to the license plate. If you have trouble installing it, take it to an audio shop, they´ll install it for you. Btw, the one that doesn´t know but doesn´t ask is stupid, not the one that asks.

You definately came to the right place to get the right answers Peter.