LI dual head install Chevy Impala LT

[LordV]

Finally have it in. Went with the upper grill placement as many had suggested.









Added the V1 placement per thestaton's request.....

[Event Horizon]

aw man thats a bad ass impala. Nice car. And the location of the heads look perfect. JTG JTG JTG

[thestaton]

that's a very nice install. where is the radar receiver.

[Laser-InterceptorUSA]

Very nice install Ken!

Congrats!

Cliff - LI-USA

[LordV]

that's a very nice install. where is the radar receiver.

The top was cutoff but it's still hard to see.....Added pics on the original post per your request.

[thestaton]

beautiful beautiful install. love that impala

[LordV]

beautiful beautiful install. love that impala

From one Impala owner to another....

[Stealth Stalker]

Any chance you could post some close-up pics of the LI heads? Did you take any in-progress pics of the head install? I'm fixin to have to go through this exact same process with my new Impala, so any help would be appreciated.

Did you dremel the grille, or what? It looks great!

I'm going to see if there is any way I can recess or flush mount the V1 remote into the upper left corner of that silver trim strip around the radio and A/C controls. I just hope there is enough depth under there to squeeze it in.

[LordV]

Any chance you could post some close-up pics of the LI heads? Did you take any in-progress pics of the head install? I'm fixin to have to go through this exact same process with my new Impala, so any help would be appreciated.

Did you dremel the grille, or what? It looks great!

I'm going to see if there is any way I can recess or flush mount the V1 remote into the upper left corner of that silver trim strip around the radio and A/C controls. I just hope there is enough depth under there to squeeze it in.

I did not take any in progress pics. This head install was a pain in the a$$ to say the least. There is hardly enough room to get your hand in there. I needed to use a flexible shaft for my drill with my wife manning the trigger just to drill and screw the brackets in. You can't work from the underside because it's completely shelled in.

Once the brackets were in, and the heads were mounted, I laid a 4 foot strip of drywall corner bracket across the front end to allow a straight edge to align the heads. I then dremeled the grill. Just butt the grill up to the heads. mark it and dremel away.

I could not find a way through the firewall either. I ran the cables up the drivers side of the engine compartment, through a gap by the hood hinge (piston), which allows access into the drivers side door area. I was then able to run them through the electrical grommet into the parking brake area. I was able to do this with no pinch points. Oh what fun....It paid off though.

[PMoth]

That install looks awesome. Great Job!!!